its not a real bad job its at the bottom of the dash in the center, the heater hoses are a real bear because you have to get those from underneath the car. go to the library and get detailed instructions
How do you change a heater core in a 95 chevy corsica?
I believe you go through the Glove Box, once it is removed the rest is simple, just reverse what you did when you pulled the worn out one.
How do you change a heater core in a 95 chevy corsica?
that sucks you have to lift the car to get to the hoses then hope your skinny enough to fit yourself underneath the dash board to take all those stupid asss tiny screws out. Good luck not loosing any
just like you would change anything else? Take the old one off and put the new one on. It will be a real *****. First locate where the heater core is. It is probably on the pass side on the lower fire wall. Peel back the carpeting (it should only be velcroed) look for a box approximately 10x7. ahhh...screw this go get a hayes manual $5.00 or free at your library.
The heater core is in the center of the dash up and right of the gas petal it sucks all u need is a 1/4 inch ratchet set with a few extensions and a few swivels u have to take off the outside where your vent lines run to and that reveals the heater core the u remove your heater hose from the firewall in the engine compartment then u go back under the dash and undo the heater core straps,remove and replace i did one on a 96 Berretta and it was a pain took about 3 hours...mostley all ove the tiny bolts are 8mm
